Share:
PolyKrete 222

PolyKrete 222

PolyKrete-222 is a two component, 100% solid epoxy system. It is high modulous, moisture insensitive and low temperature (30°F) curing system. It is used as a coating, resurfacing or repair in areas where low down time is required. At 30°F - 35°F it will yield a hard, dense, abrasion resistant surface. Above 65°F PolyKrete-222 treated surface can be opened up to traffic in as little time as three hours

Tests

Results

PolyKrete-222 | PolyKrete Gel

Test Method
Mixing Ratio ( Base:Hardener )
2:1 | 2:1 
Pot Life
15 min | 15 min
Cure Time 2 hours | 2 hours
Cure Time Mortar  
3 Hours | 3 Hours
Tensile Strength (Neat) PSI 
5000 PSI | 5000 PSI
Tensile Elongation %
1-2% | 1-2% 
Tensile Modulous PSI
400,000 PSI | 400,000 PSI
Tensile Strength (Mortar) 
2140 PSI | 2140 PSI
ASTMC-307
Compressive Strength (Neat) 10500 PSI | 10500 PSI
Compressive Strength (Mortar)
11500 PSI | 11500 PSI
Compressive Modulous 250000-400000 PSI | 250000-400000 PSI
Flexural Strength 4500 PSI | 4500 PSI
Hardness Shore D
85-90 85-90 
Abrasion Resistance 
0.19 gm. Max. | 0.19 gm. Max.
ASTMD-1044
Colors 
Various Colors | Various Colors

Features

  • Low Temperature Curing 30°F
  • High Early Strength
  • High Modulous
  • Waterproof
  • Moisture Insensitive

Uses

  • Patching
  • Chemical Resistant Flooring
  • Rapid Setting Floor Resurfacing or Coating
  • Structural Bonding

Chemical Resistance

Resistant to :

  • Mild Mineral Acids
  • Alkalies
  • Detergents
  • Solvents
  • Salts
  • Hydraulic Fluids
  • Lubricating oils
  • Etc

Surface Preparation

Surface should be sound, clean, free of oil, grease, detergents, dust, loose paint and sealants. Areas may be dry or wet but free of standing water. Use conventional methods acid etching but mechanical scarification is the best and preferred.

Mixing

Mix two part Base to one part Hardener by Volume. Mix thoroughly by scraping sides and bottom.

Application

PolyKrete-222, as soon as it is mixed thoroughly, just pour it on the floor right away in lines. Use brush or long hand roller to spread evenly. It is self levelling.

Polykrete-222 Gel

1- PolyKrete-222 is a low viscosity, high modulous adhesive and mortar binder for horizantal surfaces.

2- PolyKrete-222 Gel is a non-sag gel for vertical and overhead repairs of structural concrete, wood or steel.

Mix two part Base to one part Hardener. Mix thoroughly and use it right away or add one part sand to every one part of mixed Gel and use this mortar mix for patching.