Tests |
Results
Hydroseal | Hydroseal LV | Hydroseal Gel
|
Mixing Ratio Base/Hardener |
1:1 | 2:1 | 1:1 |
Viscosity |
7000 CPS | 800C PS | Gel |
Pot Life Minutes |
45 | 45 | 45 |
Hardness Shore D |
85 | 85 | 85 |
Tensile Strength |
4500 PSI | 5000 PSI | 4500 PSI |
Tensile Elongation |
1-3 | 1-3 | 1-3 |
Compressive Strength |
11000 PSI | 12000 PSI | 11000 PSI |
Compressive Strength PSI (Mortar) |
11000 PSI | 12000 PSI | 11000 PSI |
USES
Hydroseal Systems are intended for use on concrete and steel surfaces which are constantly or intermittently submerged in water or in splash zone areas.
Concrete Piers & Piles
Steel Sheet Piling
Wet Surface Applications
Sewage Treatment Plants
Chemical Storage Tanks
Below Grade Flooring
1- Hydroseal: Protective coating for under water and above water application.
2- Hydroseal LV: Epoxy mortar binder and pressure grout for under water application.
3- Hydroseal Gel: Heavy paste material for vertical and overhead applications.
SURFACE PREPARATION:
All surfaces should be prepared as follows:
Concrete: Concrete surface should be sand blasted, aqua blasted, scarified. All the allegies should be removed completely. New concrete can be acid etched with 15% Muriatic acid but mechanical means is the best way. Concrete surface should be free of dirt, grease, oil, loose paint. Concrete surface should be structurally sound.
Steel: Steel surface should be sand blasted to white metal with profile and should be Immediately coated with Hydroseal.
Wood: All coatings should be removed. Wood should be sanded and patched at seams.
Hydroseal
Coating: Apply under water with roller or brush. Two coats of Hydroseal are recommended.
Hydroseal LV
Mortar: Hydroseal LV can be poured in place on horizontal surface or in preformed vertical
surfaces. Hydroseal LV Mortar will displace the water and cure in place.
Hydroseal Gel
It can be applied by trowel or rubber gloves.
AGGREGATE LOADING
Hydroseal · 3 Part Sand : 1 Part Mixed Epoxy.
Hydroseal LV · 4 Part Sand : 1 Part Mixed Epoxy.
Hydroseal Gel · 1 Part Sand : 1 Part Mixed Epoxy.
COVERAGE
Coating: First coat 75-100 sq.ft./gallon, second coat 75-100 sq.ft./gallon.
Mortar: 231 cubicinches in one gallon. See the estimating chart.
CHEMICAL RESISTANCE
Hydroseal Systems are highly chemical resistant to salt water, fresh water, acids, alkalies, fungus, oils and fuels.