Tests |
Results |
Mixing Ratio
|
Base to Hardener by volume 1:1
|
Pot Life 75°F |
1 Hrs. |
Solids
|
75% |
Mixed Viscosity at 75°F
|
100 CPS
|
Tensile Strength |
4,000-5,000 PSI
|
Tensile Elongation |
1 to 5%
|
Uses
- Highways
- Bridges
- Airports
- Buildings
- Parking Garages
- Marine Decks
- Swimming Pools
Chemical Resistance
Splash & spillage of mineral acids, alkalies, aliphatic & aromatic solvents, salt, oil and water.
Joint Preparation
All foreign matter and concrete laitance must be removed by sawing and/or sandblasting prior to installation of sealant. Both concrete and steel joint surfaces should be dry and free of dust at time of installation. Steel-faced joints should also be free of paint primer, oil, etc.
Priming
PolySeal does NOT need a primer.
Mixing and Application
PolySeal is designed for application through mixing equipment capable of metering the components (2:1 by volume) and automatically mixing and extruding sealant.
Hand Mixing
Premix Part B then add entire contents of Part A, and mix thoroughly for approximately 5 minutes manually or with a paddle powered by low-speed drill. Apply with a caulking gun, or manually.
Storage
Store out of weather and direct sunlight at temperature below 100°F.
Packaging
3 gallon units
15 gallon units